Sole-Guard™ is the first product
of its kind to offer fast and effective protection and support
for the unshod foot. Simply fill the bottom of the foot with
Sole-Guard creating a protective coating that bonds to the foot
for three weeks. Sole-Guard sets firm to protect the unshod
foot, but retains flexibility to move naturally with the foot,
providing comfort and support. Sole-Guard provides complete
protection and support in on easy application. Contact your
dealer or Vettec today to see how Sole-Guard can work for you.
PLEASE NOTE
Vettec products are best used between 65° and 85° F
(18° to 29° C).
Areas of wetness or bleeding should not be covered. Once
healed, commence using products.
Use of disposable gloves is recommended.
Do not burn or “Hot Shoe” this product.
Use only Vettec mixing tips.
CARTRIDGE PREPARATION
To open the cartridge, remove the tip at line with nippers.
Insert cartridge into dispensing gun, label side up.
Before attaching the mixing tip, equalize the cartridge
by squeezing out a small amount to ensure that both sides
are dispensing evenly.
Attach mixing tip by pressing and twisting clockwise.
When finished, don’t release the pressure with
the lever on the back of the dispenser. Remove the mixing
tip immediately, discard, and replace with a cap. Push the
pressure release lever. Caps are available from your
dealer.
For additional applications, re-equalize the cartridge,
and attach a new tip.
HOOF PREPARATION
Trim and conservatively pare the sole. With hoof knife
trim and clean the frog, bars and commisuers.
DRY HOOF THOROUGHLY using a heat gun or hair dryer,
even if you don’t think it needs it. Don’t overheat.
PROCEDURE 1 - When working on level surfaces
Immediately after drying,
hold the hoof as flat and level as possible.
With the frog turned upward, dispense Sole-Guard and fill
in the sole until the desired level is achieved.
This is usually just short of the white line. Do not fill
above the level of the wall.
Place plastic sheet over sole and smooth to desired effect.
Hold the hoof for approximately 1 minute, then release.
Remove plastic sheet in approximately 5-6 minutes.
PROCEDURE 2 - When working on soft or uneven surfaces
After drying; hold the hoof and dispense Sole-Guard alowing
material to flow towards toe.
Apply a foam board to the toe region first and lay the
board towards the heel leveling the Sole-Guard material.
Hold for one minute and set the foot down.
Remove foam board after 6 minutes.
EMERGENCY/TRAIL RIDING ROCEDURES
Wire-brush the sole and frog removing all dirt and debris.
Dry the sole and frog using clean rag or towel.
Apply as above using either method 1 or 2.
Limited Remedy: Follow instructions carefully. If your
application is not covered by these instructions, call 800/483-8832
before using this product. Buyer agrees that if Vettec products
are proved defective, the user’s exclusive remedy will
be, at manufacturer’s election, to replace the defective
Vettec product or to refund the purchase price for the defective
quantity. Manufacturer is not liable for direct, indirect, incidental
or consequential damages regardless of legal theory asserted,
including assertion of negligence and strict liability.
Sole-Guard
