Back to
Instructions

 


Equi-Pak
Instant Soft Pad Material (Clear)

DOWNLOAD PDF OF INSTRUCTIONS

Télécharger la notice en format PDF
Versión Del Español De la Transferencia directa

Equi-Pak (REF 46121) is a fast setting, 25 seconds, liquid urethane hoof packing material that provides durable, shock absorbent, cushioned support which retains it’s shape and flexibility indefinitely. Equi-Pak can be used with or without a pad and adheres to the sole sealing out moisture and debris, protecting both the frog and sole. Equi-Pak will leave the sole in excellent condition, eliminating cheesy sole.
 

PLEASE NOTE
  • Vettec products are best used between 65° and 85° F (18° to 29° C). See Cold & Hot Conditions.
  • The following procedures are best accomplished wearing latex or rubber gloves.
  • Do not burn or “Hot Shoe” this product.
  • Use only recommended Vettec mixing tips.
CARTRIDGE PREPARATION
  1. To open the cartridge, remove the tip at line with nippers. Insert cartridge into dispensing gun, label side up.
  2. Before attaching the mixing tip, equalize the cartridge by squeezing out a small amount to ensure that both sides are dispensing evenly.
  3. Attach a mixing tip by pressing and twisting clockwise. If using the small 48cc cartridges, the end of the tip can be cut to create a larger opening.
  4. When finished, do not release the pressure with the lever on the back of the dispenser. Remove the mixing tip immediately, discard, and replace with a cap. The pressure can now be released. Caps are available from your dealer.
  5. For additional applications, re-equalize the cartridge, and attach a new tip.
HOOF PREPARATION
  1. Trim and conservatively pare out the sole, leaving some exfoliated sole. Clean well with a wire brush.
  2. DRY HOOF THOROUGHLY using a heat gun or hair dryer.
    Don’t overheat.
  3. If the hoof is oily, wipe the affected areas with a cloth  moistened with DENATURED ALCOHOL being careful not to saturate the hoof. Dry thoroughly. DO NOT USE ACETONE!
PROCEDURE: WITH PADS
  1. If open at heels: Place mixing tip under the pad at the heel and fill to back of the pad.
  2. If there is no access: Pre-drill a 5/16 inch hole in the pad  near the apex of the frog and nail into position under the shoe. Place mixing tip against the hole and dispense until filled to the back of the pad. Cover the hole with a small  piece of duct tape.
  3. Once set, in approximately 25 seconds, release the hoof.
  4. Replace mixing tip and repeat process as necessary.
PROCEDURE: WITHOUT PADS
  1. Wire brush the sole and dry thoroughly with a heat gun or hair dryer.
  2. Cut a piece of Equi-Mesh (REF 46030) to the outline of the shoe and place between the hoof and shoe, putting the curved side toward the sole.
  3. Nail the shoe into position. If the sole is flat, seating out the shoe is advised.
  4. With the frog turned upward, apply Equi-Pak underneath the web of the shoe and fill in the sole until the desired level is achieved. This is usually to the top of the shoe.
    NOTE: For added support, load to ground level using a Foamboard (REF 46015).
  5. Hold the hoof until the Equi-Pak sets, approximately 24 seconds, then release.
PLEASE NOTE
  • Areas of wetness, bleeding, or infection should not be covered.
    Once healed, commence using the product.
  • During hot weather conditions, Equi-Pak may cure at a higher temperature. Equi-Pak may be applied in layers to reduce heat.
  • Equi-Pak will adhere to leather and rubber pads, as well as some
    types of polyurethane pads.
COLD CONDITIONS (Below 65° F)
  • Failure to keep the hooves, shoes, and Equi-Pak warm will dramatically slow the cure time.
  • Store the cartridges in an insulated “cooler” warmed with microwaveable heat pads or 1 to 2 tightly capped gallon jugs filled with hot water.
  • In freezing temperatures, 32° F or less, the shoes must be warmed to keep condensation from forming on them and preventing the bond.
HOT CONDITIONS (Above 85° F)
  • Equi-Pak will set very quickly. To retard the set time, store the material in an insulated cooler with 1 or 2 freezer packs.

Note: During hot weather conditions, Equi-Pak may cure at a higher temperature. Under these circumstances when temperature is an issue, Equi-Pak may be applied in layers to reduce heat.

Limited Remedy: Follow instructions carefully. If your application is not covered by these instructions, call 800/483-8832 before using this product. Buyer agrees that if Vettec products are proved defective, the user’s exclusive remedy will be, at manufacturer’s election, to replace the defective Vettec product or to refund the purchase price for the defective quantity. Manufacturer is not liable for direct, indirect, incidental or consequential damages regardless of legal theory asserted, including assertion of negligence and strict liability.